Planet Technology BT-200U - Manual (Page 43)

Appendix C - Specifications
39
After this computer has been configured to provide the Network Access service to
other Bluetooth devices, it will not be able to use the Bluetooth Network Access service
provided by another Bluetooth device without being re-configured. Put another way,
this computer cannot be both a Bluetooth Network Access server and a Bluetooth
Network Access client at the same time.
5.6.8.1 Setup for Windows 98SE & Windows Me
?
NOTE:
Internet Protocol routing software is required on Windows 98SE
and Windows Me servers.
Install and configure the routing software as instructed by the
software's manufacturer.
Configure the server:
1. From the Windows Control Panel, double-click the Network icon.
2. On the Configuration tab, select TCP/IP-> Bluetooth LAN Access Server Driver
(scroll down if necessary).
3. Click Properties and select the IP Address tab.
a) Select Specify an IP address
b) Enter an IP Address (suggested value
—192.168.1.1)
c) Enter a Subnet Mask (suggested value
—255.255.255.0)
4. Click OK twice to close the dialog boxes and then click YES to restart the com-
puter.
5.6.8.2 Setup for Windows 2000 and Windows XP
If Internet Connection sharing was previously enabled (before BTW was installed) it
must be disabled and then re-enabled before the Bluetooth network adapter can use it.
Please find section 7.8 for more information.
Configure for Network Access:
1. From the Windows system tray, right-click the Bluetooth icon and select Advanced
Configuration from the shortcut menu.
2. In the Bluetooth configuration panel, select the Local Services tab, Network Ac-
cess and then click Properties....
3. From the Network Access, General properties page, in the Type of service short-
cut menu, select
“Allow other devices to access the Internet/LAN via this
computer,
” and then click Configure Connection Sharing.
4. Right-click Local Area Connection, select Properties and then select the Sharing
tab.
5. Select Enable Internet Connection Sharing for this connection, click OK, and then
click YES in the confirmation dialog box.
5.6.8.3 Configure for Group Ad Hoc Networking:
1. From the Windows system tray, right-click the Bluetooth icon and select Advanced