Planet Technology BT-200U - Manual (Page 9)

Installation
5
11. Remember to restart your computer to have the new configuration take effect if the
following message is shown.
2.2 Hardware installation
Note: The hardware installation should be only performed when the software is
well installed.
Precaution
Before the installation, make sure the USB port exists in your computer and is enabled.
To check this, go to My Computer
àControl Panel àSystem. Open the Device
Manager tab. If the Universal Serial Bus controller device is found, it means your
USB port is installed and enabled. If not, either no USB port is installed or the USB
bios is not properly enabled. In this case, consult your computer dealer for USB sup-
port.