Pioneer DVR-320-S - Manual (Page 44)

Recording 06
44
En
Basic recording from the TV
Follow the instructions below to record a TV program.
Recording starts immediately and continues until the
disc is full or you stop the recording.
1 Load a recordable disc.
• If you load a new blank DVD-RW disc, the recorder
takes a short while to initialize the disc.
2 Use the CHANNEL +/– buttons to select the TV
channel to record.
The front panel display shows the channel number:
• While the recorder is stopped, you can also use the
number buttons on the remote to select the channel.
(For channel 6, press
6 then ENTER ; for channel 24,
press 2, 4 then ENTER )
• If the recorder is stopped, you can also use the +/–
buttons on the front panel to select the channel
number.
3 Use the REC MODE button to set the picture
quality/recording time.
• See Setting the picture quality/recording time above
for detailed instructions.
4 Use the AUDIO button to select the audio
channel to record.
See Changing audio channels on page 27 for more on
this.
• When recording in VR mode, both mono and SAP
audio channels are recorded, allowing you to switch
the audio channel on playback. The only exception to
this is when the picture quality is set to
FINE / MN32 ,
in which case you do need to select the audio
channel before recording.
5 Press ì REC to start recording.
If you want to set a recording end time, press the
ì REC
button repeatedly. The recording time increases in 30
minute increments, up to a maximum of six hours. The
time the recording will end is shown on-screen and in the
front panel display. When the recording ends, the
recorder automatically switches into standby if no other
operation is being performed.
• To cancel the set recording time, press ì REC .
• If you want to pause recording at any time, press
PAUSE . Press again to restart the recording. (If
recording in VR mode, a new chapter is started after
recording restarts)
6 To stop the recording, press STOP REC.
• If you set the recording time in the previous step, you
can still stop the recording anytime by pressing
STOP REC .
• Recording will stop automatically when there is no
more space on the DVD.
Setting a timer recording
Using the timer recording features you can program up
to 32 timer recordings up to a month in advance. Timer
recording programs can be set to record just once, every
day, or every week.
You can set the recording quality for your timer recording
in the same way as for a regular recording, but with the
added option of an
AUTO mode, which maximizes the
recording quality for the space available on the disc.
You can also set the recorder so that it will adjust the
recording quality to try and fit the recording on to the disc
if it would not otherwise fit at the recording quality you set
(see
Optimized Rec on page 83 for more on this).
VR mode Video mode
AUDIO
ENTER
CHANNEL
REC
PAUSE
STOP REC REC MODE
ì
2 3 3 0 7
Channel preset
PR
VR mode Video mode
RL_s Singapore.book 44 ページ ２００４年４月２３日 金曜日 午後８時１１分