Pioneer DVR-320-S - Manual (Page 80)

The Initial Setup menu 12
80
En
Note
• When set to Off , all the other Audio Out settings are
grayed out and can’t be set.
Dolby Digital Out
You only need to make this setting if you connected this
recorder to an AV amp/receiver (or other component) using
the digital output.
• Default setting: Dolby Digital
If your AV amp/receiver (or other connected component)
is Dolby Digital compatible, set to
Dolby Digital ,
otherwise set to Dolby Digital PCM . Check the
manual that came with the connected component if
you’re unsure whether it is Dolby Digital compatible.
DTS Out
You only need to make this setting if you connected this
recorder to an AV amp/receiver (or other component) using
the digital output.
• Default setting: On
If your AV amp/receiver (or other connected component)
has a built-in DTS decoder, set to
On , otherwise set to
Off . Check the manual that came with the connected
component if you’re unsure whether it is DTS
compatible.
Important
• If you set to On with a non-DTS compatible amp/
receiver, noise will be output when you play a DTS
disc.
• When set to On , there is no analog audio output
when playing a DTS DVD-Video disc.
• When playing a DTS audio CD (even when DTS Out
is Off ), noise is output from the analog outputs. Do
not play this through your amplifier and speakers.
• When playing a DTS audio CD, make sure that
Stereo is selected using the AUDIO button. See
Switching audio channels on page 41.
96kHz PCM Out
You only need to make this setting if you connected this
recorder to an AV amp/receiver (or other component) using
the digital output.
• Default setting: 96kHz 48kHz
If your AV amp/receiver (or other connected component)
is compatible with high sampling rate audio (88.2 / 96
kHz), set to
96kHz , otherwise set to 96kHz 48kHz .
Check the manual that came with the connected
component if you’re unsure whether it is compatible with
high sampling rate audio.
MPEG Out
You only need to make this setting if you connected this
recorder to an AV amp/receiver (or other component) using
the digital output.
• Default setting: MPEG PCM
If your AV amp/receiver (or other connected component)
is MPEG audio compatible, set to
MPEG , otherwise set to
MPEG PCM . Check the manual that came with the
connected component if you’re unsure whether it is
MPEG compatible.
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback Digital Out
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out Dolby Digital
Dolby Digital
PCM
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback Digital Out
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out On
Off
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback Digital Out
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out 96kHz 48kHz
96kHz
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback Digital Out
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out MPEG
MPEG
PCM
Initial Setup
RL_s Singapore.book 80 ページ ２００４年４月２３日 金曜日 午後８時１１分