Pioneer DVR-320-S - Manual (Page 47)

Recording 06
47
En
• You can also clear a timer program before it’s started
(before the recorder enters timer recording standby)
by highlighting it and pressing
CLEAR .
2 Select ‘New Input’ to set a new timer program,
then press ENTER.
3 Enter the timer recording settings.
Use the / (cursor left/right) buttons to select a field;
use the / (cursor up/down) buttons to change the
value.
• Date – Choose a date up to one month in advance, or
select a daily or weekly program.
• Start – Set the recording start time.
• Stop – Set the recording end time (maximum length
of a timer recording is six hours).
• CH – Choose a channel (1–99, excluding skip
channels), or one of the external inputs from which to
record.
• Mode – Select FINE , SP , LP , EP or AUTO (See
Recording time and picture quality on page 42). If
Manual Recording is on, then you can also select the
MN setting.
• Ttl Name Input – Optionally, you can enter a name
for the recording up to 32 characters. (Highlight
Program Set then press (cursor down) to access
this option.)
4 After entering all the timer recording
information, highlight ‘Program set’ and press
ENTER.
The timer recording list screen is displayed again. The
timer program you just input appears in the list. The
rightmost column shows various timer recording status
messages:
• If there are already the maximum number of titles or
chapters on the disc, the message Title Over or
Data Over appears. (There can be up to 99 titles on
a disc.)
• If a timer program overlaps another in the list, the
message Overlap appears.
• If no recordable disc is loaded, the message Can’t
Rec appears.
• Standby is displayed when the recorder is in timer
recording standby.
• Recording is displayed when a timer recording is in
progress.
5 To exit the timer recording screen, press HOME
MENU.
Note
• The rightmost column in the timer recording screen
( Confirm ) shows whether there’s enough space to
record your timer program. If you selected a daily or
weekly program, the date of the last recording that
will fit on the disc appears (up to a maximum of one
month ahead).
• If the timer program is too long to fit into the available
disc space, the message Time Over appears. The
program will record until the disc is full.
• If Optimized Rec (see Optimized Rec on page 83) is
set to On , the recorder will adjust the recording
quality to try and fit the recording on the disc. If the
program is too long even when recorded in
EP
(extended play), the message Time Over appears.
Timer recording using the G-Code™
programming system
This system makes programming timer recordings very
simple. Most TV guides publish G-Code programming
numbers with their program details. If you want to make
a timer recording of a program, you just input the
corresponding code. The date, start, stop and channel
settings are made automatically. All you have to do is tell
the recorder the recording mode, and whether it’s a
once-only recording or a regular recording.
Date Start Stop CH Rec Mode
SUN 12/12 10 00 11 00 Pr 7 SP
Timer Recording
Ttl Name Input
Program Set
HOME
MENU
ENTER
CLEAR
REC MODE
ì
G- CODE
RL_s Singapore.book 47 ページ ２００４年４月２３日 金曜日 午後８時１１分