Pioneer DVR-320-S - Manual (Page 48)

Recording 06
48
En
1 Press ‘G-Code’ to display the G-Code program
screen.
You can also access this screen from the Home Menu
(press
HOME MENU , select Timer Recording , then G-
Code ).
• Use the
number buttons to enter the G-Code programming
number. (To clear the last digit entered, press
CLEAR .)
• Press REC MODE to select FINE , SP , LP , EP or AUTO
(See Recording time and picture quality on page 42). If
Manual Recording is on, then you can also select the
MN setting.
• Use the
/
(cursor left/right) buttons to select the
Once , Daily or Weekly recording option.
2 After making the settings, press ENTER.
The program details are shown at the bottom of the
screen for a few seconds then the screen is automatically
exited.
• If you haven’t set up the guide channels (or at least
the guide channel for the number that you entered),
the recorder will prompt you to enter the channel
number that the TV program is showing on.
Tip
• You can check the timer program settings by
pressing TIMER REC to display the timer recording
screen.
G-Code programming with the power off
You can enter a G-Code programming number when the
recorder is in standby.
Important
• You can’t use this feature until you have set up the
guide channels. See G-Code CH Setting on page 77.
• You can’t change the recording mode.
• You can’t program daily or weekly timer recordings.
1 Press ’G-Code’.
The front panel display shows the current recording
mode and prompts you to enter the G-Code programming
number.
2 Use the number buttons to enter the number.
• To clear the last digit entered, press CLEAR .
3 Press ENTER.
The display shows the timer settings:
Date
Start time End time Recording channel.
• If CODE ERROR appears in the display, check that
the number is correct and that the guide channel is
set (see
G-Code CH Setting on page 77), then set the
timer recording again.
• If CAN’T SET appears in the display, it means that
although you entered a valid number, the program
has already finished.
Extending a timer recording in progress
You can extend a timer recording beyond the
programmed end time in two different ways. This can be
useful if a broadcast program overruns, for example.
to input 3 9 9 2 4 0 9 G-Code#
Rec Mode
Rec Times
G-Code
MN21
Once Daily Weekly
REC MODE to change
to change level
to change
ENTER
CLEAR
G- CODE
G - COD E
2 9 32 4
HOME
MENU
ENTER
CLEAR
REC
PREV NEXT
STOP REC TIMER REC
ì
RL_s Singapore.book 48 ページ ２００４年４月２３日 金曜日 午後８時１１分