Download code – Paradyne 8510 User Manual
Page 120
A. Download Code
A-2
April 2001
8000-A2-GB26-50
Download Code
When you are attempting to download to the DSL cards, refer to
in Chapter 3, DSL Card Configuration. In general, the following describes
what to expect when you have initiated a download from the configuration menu.
From the DSL Configuration Main Menu, follow the menu selection sequence:
Configuration
→
Card
→
Download Code (A-A-F)
This brings you to the Download Code submenu. Select Download Code (A).
Before initiating a download, go to the MCC card and verify that you can Ping the
TFTP server. If you cannot, do not proceed with the download. Also, make certain
that the files that you are going to download from exist in the system.
When the file transfer has successfully completed, you must manually apply the
download for the system to restart and become fully functional with the newly
acquired firmware.
NOTE:
To download code to the Service Node(s), you must use the MCC download
menu. For information on this and other methods used to download firmware
to the DSL and MVL cards, see Configuration Menu Options in the
Management Communications Controller (MCC) Card, IP Conservative,
User’s Guide
.