Paradyne 8510 - Manual (Page 123)

8000-A2-GB26-50 April 2001 B-1
B
Traps
DSL Card Traps
Traps are configured via a Telnet or terminal session. The addition or removal of a
card or another hardware component within the Hotwire DSL system causes a trap
to be generated. These traps indicate a configuration change notification (CCN) of
a card (a hardware replacement or a software upgrade).
Table B-1. DSL Card Traps (1 of 3)
Event Severity Comment Trap # MIB
CCN
(Configuration
Change Notice) warning Configuration change caused
by one the following events:
T Software download.
T Configuration download.
T Card removed (objective).
7 hot_sys.mib
(Hotwire system)
warning Configuration change
affecting the entity MIB. 1 hot_domain.mib
(Enterprise MIB)
Cold start warning Card has been reset and
performed a cold start. 0 MIB II
(RFC 1213)
Configuration
download
failure warning Configuration download has
failed. 2 hot_diag.mib
(Hotwire
diagnostics)
Device failure major Access Node’s software has
detected an internal device
failure. 15 hot_sys.mib
(Hotwire system)
DHCP Address
in Static Subnet minor The DHCP server is
attempting to assign an
address in the range of static
subnet on a different port. 19 hot_sys.mib
(Hotwire system)
DHCP filter
security failure minor Cannot add new route; route
table contains maximum
number of rules. 11 hot_dhcp.mib
(Hotwire DHCP
Relay Agent)