Paradyne 8510 - Manual (Page 66)

3. DSL Card Configuration
3-30 April 2001 8000-A2-GB26-50
Table 3-5. Service Node Options
SN Configuration A-F
Displays endpoint information for the service node (SN).
NOTE: Although the System Name, System Contact and System Location can be
entered on this screen, DSL Router SNs use and display the SNMP information set via
the System Group.
Interface Name – Enter the DSL interface. Valid choices for the DSL card are dsl1:1
through dsl4:1 = 4-port DSL card interface; dsl1:1 through dsl12:1 = 12-port DSL card
interface, dsl1:1 through dsl24:1 = 24-port DSL card interface (Default = dsl1:1).
SN Type – Model number of SN connected to the DSL port as entered on the DSL Ports
screen (A-B-B). (This field is read-only.)
System Name – 16 alphanumeric characters. Enter the name assigned to the SN
(Default = nobody).
System Contact – 32 alphanumeric characters. Enter the name or number of the person
responsible for the SN (Default = noname).
System Location – 16 alphanumeric characters. Enter the location of the SN
(Default = nowhere).
System Circuit ID – 32 alphanumeric characters.
Model Num – Model number of card. (This field is read-only.)
Serial Num – Serial number of card. (This field is read-only.)
Firmware Rev – Version of firmware. For DSL Router SNs, data from both active and
alternative firmware banks is displayed. (This field is read-only.)
Hardware Rev – Version of hardware. (This field is read-only.)
DSP Rev – Version of GlobeSpan chipset. (This field is read-only.)
IUT Revision – Version of the ISDN U-Interface Transceiver (IUT) for Model 8303/8304
IDSL cards only. (This field is read-only.)
Switch SN Firmware & Reset? – Yes/No. For DSL Router SNs, enter yes to have the
DSL Router SN load firmware from the alternate bank after a firmware reset. This field
does not appear for MVL or ReachDSL/MVL cards.
Reset SN? – Yes/No. Enter yes to reset the SN and begin a self-test.
NOTE: Entering yes in the Reset SN field will temporarily disrupt the data path on the
specified DSL port while the SN resets.
SN Switch Result – The results of the program switch on the SN.
SN Selftest Result – Pass/Fail. This field displays the results of the SN self-test, when
completed.