Paradyne 8510 - Manual (Page 34)

2. Hotwire Menus and Screens
2-14 April 2001 8000-A2-GB26-50
The following information is displayed on the Port Card Select screen.
For example, the following may be displayed on the Port Card Select screen:
Position: 1 2 3
Line 1: 1: 8510 PC Status _ _ _ 10bT
Line 2: RADSL(4) U D D D
Line 3: Eth(1) U
This display shows the following:
T There is an 8510 port card with a 10 BaseT interface in Slot 1
— Position 1 – No current test ( _ )
— Position 2 – No major alarm is present ( _ )
— Position 3 – No minor alarm present ( _ )
T This RADSL card has four ports. Port 1 is up, while Ports 2 through 4 are
down.
T There is an Ethernet uplink (one port) and the link is up.
Column
Heading
Display Description
Slot <slot number> Slot number of card in chassis.
Card <card type> Model number of card such as 8510, 8312,
8343, etc.
Type
(1st line) PC Stat Port card status.
Status
(1st line) Position 1: T or _ Test mode. Card currently in test mode or _ for
no active test.
Position 2: M or _ Major alarm. Major alarm present on card or _
for no active major alarm.
Position 3: R or _ Minor alarm. Minor alarm present on card or _
for no minor alarm active.
<descriptive text> Up to 42 characters of additional information
about the card (IP Conservative software) and
status of the card (Active or Spare).
Type
(2nd line) RADSL, MVL, SDSL, etc.
(1–24) DSL type (number of ports).
Status
(2nd line) <port status> Port status: U=Up, D=Down, X=Disabled/Not
Initialized
Type
(3rd line) Eth, etc. (1) Uplink type (number of ports).
Status
(3rd line) <uplink status> Status of uplink:
U=Up, D=Down, X=Disabled/Not Initialized,
L=Loopback, A=Alarm