Paradyne 8510 - Manual (Page 56)

3. DSL Card Configuration
3-20 April 2001 8000-A2-GB26-50
Configuring VNID(s) on a DSL Card
A VNID is a Virtual Network Identifier known as the 802.1Q tag between port cards
with an Ethernet network interface and the Interworking Packet Concentrator
(IPC). This directs traffic between the ISP and the end user. Tagging occurs
between the DSL card and the IPC to ensure that data is sent to the correct
location. This helps to ensure that data is not broadcast to all ports when Mux
forwarding is enabled. To enable VNID tagging for port cards with an Ethernet
network interface, you must first ensure that matching groups are configured on
the IPC.
T VNID configuration is required on DSL port cards when the port card is
operating in the VNET-Bridged mode. However, when a DSL port card with an
ATM Network interface is operating in Standard mode, no VNID configuration
is required.
T 802.1Q VLANs must be configured on the IPC when a DSL port card with an
Ethernet Network interface is used. However, 802.1Q VLANs are not required
when a DSL port card with an ATM Network interface is used in conjunction
with an SCM card in the Hotwire 8820 GranDSLAM.
Before configuring VNIDs, you must enable VNID tagging (A-E-A), then reset the
card.
NOTE:
Before configuring VNIDs, determine what type of endpoints are attached.
Desired DSL port card configuration settings may differ, depending on the SN
attached.
Procedure
To configure at least one VNID for this DSL card from the Hotwire – DSL Card
menu:
1. Follow this menu selection sequence:
Configuration
→
Bridge
→
Card VNID Table (A-E-B)
2. Type 0 or press Enter at the Item Number(0 to add new item):
prompt.
3. Enter the VNID (2–4000 for port cards with an Ethernet Network interface or
2–255 for port cards with an ATM Network interface) at the Enter VNID ID
prompt.
4. Enter enabled at the Enabled/Disabled: prompt in the Mux Fwd field.
(Default = enabled.)
5. Enter disabled at the Enabled/Disabled: prompt in the IP Filter field.
(Default = disabled.)