Hardware installation and setup, Installing the rmx 1500, Mounting the rmx 1500 in a rack – Polycom DOC2560C User Manual
Page 41: Hardware installation and setup -9, Installing the rmx 1500 -9, Mounting the rmx 1500 in a rack -9
Polycom RMX 1500/2000/4000 Getting Started Guide
2-9
Hardware Installation and Setup
The RMX 1500/RMX 2000 unit should be mounted in a 19”rack in a well
ventilated area. The RMX 4000 unit can be mounted in a 19” or 23”rack in
a well ventilated area. It is important to adhere to the Site Requirements as
described in the RMX 1500 & RMX 1500/2000/4000 Hardware Guides, ”Site
Requirements” on page
1-3
.
Installing the RMX 1500
The following procedures have to be performed to install the RMX 1500 in
your site:
•
Installing the RMX in a rack or as a standalone
•
Connecting the RMX 1500 to the power source
•
Connecting the network (LAN, IP and ISDN) cables to the RMX.
Mounting the RMX 1500 in a Rack
There are two methods for installing the RMX in a 19” rack:
•
Using the chassis runners on the RMX 1500
—
Install the chassis runners provided by Polycom in the rack using
the screws supplied by the rack manufacturer; two screws per
chassis runner.
For detailed instructions, precautions and requirements for installing the RMX
1500 refer to the Polycom RMX 1500 Hardware Guide.