Precor Cardio Theater Integrated Bracket Assembly Instructions EFX LCD - Manual (Page 11)

Cardio Theater Integrated Bracket Assembly Instructions
page 11
14. Continue to feed the cable with its connectors
through the lower support.
Start with the coaxial and power extension
connectors. Feed them into the lower support.
Continue to slide the cable and its connectors
so no excess remains at the gap between the
upper and lower supports. Ask your assistant to
release pressure on the upper support and
realign the mounting holes between the upper
and lower supports.
CAUTION: Be careful! A height adjuster screw
protrudes inside the base tube. Cables can
get caught and fingers scratched on the
screw threads.
15. Pull the cable and its connectors out of the
lower support and base tube.
Note: Remember to leave about 3 feet
(1 meter) of cable hanging out of the hole in the
display console bracket.
CAUTION: The next step requires the use of
a drill and the safety considerations that go
along with operating power tools. Protect the
work surfaces. Take the necessary steps to
avoid injury to yourself or damage to the
surrounding area and equipment.
16. Drill a hole in the end cap.
Use the ⁷⁄₈-inch drill bit to drill a hole through the
center of the end cap.
17. Feed the cable and its two connectors through
the hole in the end cap.
18. Replace the end cap in the base tube.
14
15
16
17
18
Upper
support
Preparing the EFX546i
Lower
support
Base tube
End cap Coaxial
connector
Power connector
Read CAUTION above step 16.
End cap