Precor Cardio Theater Integrated Bracket Assembly Instructions EFX LCD - Manual (Page 18)

Cardio Theater Integrated Bracket Assembly Instructions
page 18
16. Pull the cable and its two connectors out of the
lower support and base tube.
Note: Remember to leave about 3 feet
(1 meter) of cable hanging out of the hole in the
display console bracket.
17. Secure the upright support by replacing the four
fasteners set aside in step 5.
CAUTION: The next step requires the use of
a drill and the safety considerations that go
along with operating power tools. Protect the
work surfaces. Take the necessary steps to
avoid injury to yourself or damage to the
surrounding area and equipment.
18. Drill a hole in the end cap.
Use the ⁷⁄₈-inch drill bit to drill a hole through the
center of the end cap.
19. Feed the cable and its two connectors through
the hole in the end cap.
20. Replace the end cap in the base tube.
Preparing the EFX556i
Rubber
grommet
Upright
support
17
16
Lower support
Base
tube
18
20
19
Read CAUTION above Step 18.
End cap
End cap
Coaxial/power
cable