Panasonic KX-FPC141 - Manual (Page 107)

107
Answering
Device
Remote command
Operating from a remote location
The following operations can be performed from a remote location using a touch tone telephone.
Program the remote operation ID (p. 108) and set the unit to the TAD/FAX mode before going out (p. 96).
Dial Key Page Dial Key Remote command Page
Skips the greeting message
Repeats a message
Skips a message
New message playback
All message playback
Room monitor
Re-records a greeting message
Stops re-recording of a greeting
message
9
7
6
5
4
2
1
0 111
109
109
109
109
110
110
110
Erases a specific message
Erases all messages
Changes to the TEL mode
Turns ON message transfer for
incoming messages
Turns OFF message transfer for
incoming messages
Turns ON pager call for incoming
messages
Turns OFF pager call for
incoming messages
8 4
8 3
8 2
8 1
8 0
5
4 110
110
111
111
111
111
111
Remote operation card
Please cut out and carry this card for assistance when using the remote operation.
Answering Device
Remote Operation Notice of Remote Operation
Fold here
1. Call your unit.
2. Enter the remote operation ID
during the greeting
message.
● The new recorded
messages will be played
automatically.
3. Press the remote command
key(s) (see the reverse side)
within 10 seconds.
If there are no new
messages in step 2, press
the remote command key(s)
within 4 seconds or wait for
4 seconds, and all the
recorded messages will be
played back.
● The remote operation is
available only from a touch
tone telephone when the unit
is in the TAD/FAX mode.
● When the unit is in the TEL
mode, call your unit and wait
for 15 rings. The answering
device will temporarily answer
the line. Enter the remote
operation ID during the
greeting message. The unit will
switch to the TAD/FAX mode.
● When you press a key, press
firmly.
● To send a document, press
. When a fax tone is
heard, start transmission.
9
Remote Operation