PSC FALCON 315 - Manual (Page 13)

Quick Start
Toolbar
Found under the menu bar, the toolbar provides shortcuts to major features. The toolbar
can be turned on or off by changing the Toolbar parameter found on the
View menu. The
shortcuts available from the toolbar are as follows.
Create a new terminal configuration.
Open an existing terminal configuration.
Save the current terminal configuration.
Download the configuration to the terminal.
Download software to the terminal.
Configure terminals automatically over the wireless network.
View the PowerNet Twin Client Manager version.
The PowerNet Twin Client Manager is now successfully installed and ready for use.
Quick Start provides detailed instructions for quickly configuring the terminal and
starting a Telnet session.
Quick Start
Quick Start describes how to prepare the Twin Client Manager and the PSC terminal for
a Telnet session with the host. Following an initial setup procedure, the terminal software
and configuration are managed automatically over the wireless network.
Configuring the Manager
The first step is to configure the Twin Client Manager to meet site-specific requirements,
and then prepare it for the automatic management of the terminal software and IP
addresses. This simple procedure will require only a few minutes to complete.
Setting the Emulation
Click on Start , Programs , PowerNet , and Twin Client Manager . Select the Settings
menu, as shown below.
Supported Equipment Manual
• May, 2006 2-5