PSC FALCON 315 - Manual (Page 28)

Terminal Setup
Printer Type
This scrolling list selects the attached printer type. The default value is none , indicating
that no printer is attached.
Terminal Setup Using Twin Client Menus
For compatibility with other PowerNet products, the PowerNet Twin Client for PSC also
supports the standard Twin Client configuration menu system on the terminal. This menu
system is accessed by pressing uppercase
C at the Twin Client main menu below.
Twin Client
© 1991-2006, Connect, Inc.
Keypress to Continue
The following menu appears.
Edit Network
Edit Mobile Unit IP
Edit Server/Host IPs
Edit License Key
Run Site Survey
Switch Client Modes
Run Client Emulator
Exit to OS
Use the Up-Arrow and Down-Arrow keys to navigate the menu, and press Enter to select
the highlighted option. Each menu option is described below.
Edit Mobile Unit IP
The IP list contains the terminal IP address, the Subnet Mask and the Router IP address.
Enter the appropriate address. Select
F3 to save and/or F7 to Quit, as shown below.
IP 206.232.71.38
SN 255.255.255.0
RT 206.232.71.1
<F3> Save <F7> Quit
Edit Server/Host IPs
If the host IP address(es) were not pre-configured as described in the Setting the Servers
section of Configuring the Manager, or if you wish to change those settings using the
terminal menus, select this option and enter up to four Host IP addresses as required.
Host 0
IP 206.183.67.155
Port 23__
<F3> Save <F7> Quit
Supported Equipment Manual
• May, 2006 2-20