Powerware Ferrups FE/QFE 500VA - Manual (Page 39)

External Bypass Switch Installation
33 Powerware ® FERRUPS FE/QFE UPS (500 VA–18 kVA) Installation Guide
:
Rev A www.powerware.com
8. Find the terminal strip inside the bypass switch. Using the label
on the back of the switch’s lower front cover panel, wire the
terminal strip and tighten all connections securely. Use copper
wire and the appropriate wire size for the current. See Figure 7
for sample terminal strip labels.
BPE-01
BPE-02,
BPE-04,
and
BPE-05
Figure 7. External Bypass Switch Terminal Strip Labels
9. Using the installation wiring diagram, wire the UPS terminal
strip and complete the AC wiring.
NOTE Terminal strip connections should be exactly as shown in the installation
wiring diagram to ensure proper phasing. Good ground connections are necessary to
reduce electrical noise and ensure safe operation of the UPS and the load.