Powerware 9135 Two-in-One UPS 5000/6000 VA - Manual (Page 55)

OPERATION
EATON Powerware ® 9135 Two−in−One UPS (5000/6000 VA) User’s Guide S 164201726 Rev 1
www.powerware.com
49
Turning the UPS Off
To shut down the UPS:
1. Press the button for approximately three seconds
The UPS beeps once, and the load is no longer protected by the
UPS. It is powered by utility power. If the UPS is set in frequency
converter mode, the equipment will not be powered.
If the utility power is out of tolerance, the UPS will generate a
10 ms output calibrated break.
2. For a full shutdown of UPS and connected load, the upstream
circuit breaker (not included) should be set to the OFF position.
Operating Modes
The Powerware 9135 front panel indicates the UPS status through the
UPS indicators. Figure 30 shows the UPS front panel indicators and
controls.
esc
Power On Indicator
On Battery Indicator Bypass Indicator
Alarm Indicator
On/Off Button
Lit
Flashing
Unlit
Indicator Legend
Figure 30. UPS Front Panel