Powerware 9135 Two-in-One UPS 5000/6000 VA - Manual (Page 64)

ADDITIONAL UPS FEATURES
EATON Powerware ® 9135 Two−in−One UPS (5000/6000 VA) User’s Guide S 164201726 Rev 1
www.powerware.com
58
USB Port
The UPS can communicate with a USB−compliant computer using
Powerware LanSafe
® Power Management Software or other
HID−compliant power management software compatible with Microsoft ®
Windows ® 2000 and XP operating systems that support HID devices.
NOTE The latest versions of the Powerware LanSafe Power Management Software and
the USB firmware are available at www.powerware.com.
To establish communication between the UPS and a computer:
1. The USB port is hot−pluggable. Connect the USB cable to the USB
port on the UPS rear panel (see Figure 35).
Connect the other end of the USB cable to the USB port on your
computer.
BATT. NO. RPO CONTACTS RS−232
DO NOT DISCONNECT UNDER LOAD BATTERY CABLE CAUTION:
CONNECTOR
180Vdc
GROUP 1
SWITCHED GROUP 2
SWITCHED
BATTERY
USB Port
Figure 35. The USB Port
2. Install the Powerware LanSafe Power Management Software and
USB drivers according to the instructions provided at
www.powerware.com.