Panasonic AJ-HDX900E - Manual (Page 12)

12
2-2 Audio function section (input system)
1
2
3
5
6
7
9
; : < = >
? @ 4 8
1 MIC IN (microphone input) jack (XLR, 5-pin)
Connect the microphone (optional accessory) here. The
power for the microphone is supplied from this jack.
<Note>
Components of 150 Hz are removed from the signals
input from this connector.
2 AUDIO LEVEL CH1/CH2 (audio channel 1 & 2
recording level adjustment) controls
When the AUDIO SELECT CH1/CH2 switch 3 is set to
MAN, the recording level of audio channels 1 and 2 can
be adjusted using these controls.
The controls come with a locking mechanism. Therefore,
to adjust the recording level, simultaneously push in and
turn the controls.
3 AUDIO SELECT CH1/CH2 (audio channel 1 & 2
automatic/manual level adjustment selector) switch
This is used to select the method for adjusting the
recording levels of audio channels 1 and 2.
AUTO : Set here for automatic adjustment.
MAN : Set here for manual adjustment.
4 AUDIO IN (audio input selector) switch
These are used to select the input signals to be recorded
on audio channels 1 and 2.
FRONT :
The input signals supplied from the microphone which
has been connected to the MIC IN jack 1 are
recorded.
W.L. (wireless) :
The input signals from the slot-in wireless microphone
receiver are recorded.
REAR :
The audio input signals supplied from the audio
component which has been connected to the AUDIO IN
CH1/CH2 connectors 5 are recorded.
<Note>
When you use stereo microphone (AJ-MC900G optional),
set both CH1 and CH2 to [FRONT]. The signal from L CH
is recorded to CH1 and that from R CH to CH2.
5 AUDIO IN CH1/CH2 (audio input channel 1 & 2)
connectors (XLR, 3-pin)
An audio component or microphones are connected here.
This unit does not support AES/EBU signals.
6 LINE/MIC/+48V (line input/mic input/mic input + 48V)
selector switch
This is used to switch the audio input signals from the
audio component which has been connected to the
AUDIO IN CH1/CH2 connectors 5.
LINE : The audio input signals from the audio component
serving as the line input are selected.
MIC : The audio input signals from the internal power
supply type of microphone are selected. (The
phantom mic power is not supplied from the unit.)
+48V : The audio input signals from the external power
supply type of microphone are selected. (The
phantom mic power is supplied from the unit.)
7 Wireless receiver slot
The UniSlot wireless receiver (optional accessory) can be
attached here.
8 FRONT AUDIO LEVEL (audio recording level
adjustment) control
This enables the recording level of audio channels 1 and
2 to be adjusted.
However, when the AUDIO SELECT switch is set to the
AUTO position, the audio recording level is automatically
adjusted.
When the <MIC/AUDIO1> screen is opened from the VTR
MENU page by performing a menu operation, whether to
enable or disable the operation of this level control can be
set using the FRONT VR CH1 and FRONT VR CH2
setting items.
Chapter 2 Parts and their functions
(continued)