Planar PD8130 - Manual (Page 27)

Installation
Planar PD8130/PD8150 Installation/Operation Manual 13
PREL
IMINA
RY
3.1
Remote Control
To install batteries in the remote control:
1. Slide the battery compartment cover in the direction of the arrow to
remove it.
2. Install two AA batteries with the correct polarity.
3. Replace the cover.
Notes on Batteries • Make sure that the battery polarities are correct when installing the batteries.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to
avoid damage from battery leakage.
Notes on Remote Control
Operation
• In most situations, you can simply point the remote control at the screen
which will reflect the IR signal from the remote back toward the IR receiver on
the projector. In some cases, however, ambient conditions may prevent this.
If so, point the remote control at the projector and try again.
• If the effective range of the remote control decreases, or it stops working,
replace the batteries with new ones.
• The remote control may fail to operate if the infrared remote sensor is
exposed to bright sunlight or fluorescent lighting.
3.
Installation
1. 2. 3.