Pioneer VSX-LX70 - Manual (Page 3)

Voltage selector
You can find the voltage selector switch on the rear
panel of multi-voltage models.
The factory setting for the voltage selector is 220 V.
Please set it to the correct voltage for your country
or region.
Before changing the voltage, disconnect the AC power
cord. Use a medium size screwdriver to change the
voltage selector switch.
Medium size
screwdriver
D3-4-2-1-5_En
Changing the TV format setting
If the System Setup menu is not displayed correctly, it
may be that the TV system is set incorrectly for your
country or region.
1 With the receiver in standby, press STANDBY/
ON while holding down the SETUP button.
2 Select PAL/NTSC using / , then select PAL or
NTSC using
/ .
The display shows the new setting ( PAL or NTSC).
Changing the frequency step
If you find that you cannot tune into stations
successfully, the frequency step may not be suitable for
your country/region. Heres how to switch the setting:
1 With the receiver in standby, press STANDBY/
ON while holding down the SETUP button.
2 Select FREQ.STEP using / , then select 9k or
10k using
/ .
The display shows the new setting:
220 V 230 – 240 V
9k
10k
VSX_LX60LX70.book 3 ページ ２００７年７月１８日 水曜日 午前１０時１９分