Pioneer VSX-LX70 - Manual (Page 72)

Using other functions 11
72
En
Checking your system settings
Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
1 Press STATUS to check the system settings.
These appear on the front panel display.
1
The front panel display shows each of the following
settings for two seconds each:
2 When you’re finished, press STATUS again to
switch off the display.
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the SETUP button on the front
panel, press STANDBY/ON .
The display shows RESET NO .
3 Press the ENTER button on the front panel.
4 Select RESET using / , then press the ENTER
button on the front panel.
The display shows RESET? OK .
5 Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Note
1 If the Pure Direct mode is switched on, some settings above will show OFF , even though they are on.
Input source
↓
Surround Back Processing
↓
MCACC preset
↓
ZONE 2 / REC SEL
↓
ZONE 3
↓
HDMI Control
SHIFT
STATUS STATUS
MCACC S.DIRECT
MULTI OPE
SIGNAL SEL
T.DISP
SBch STEREO/ F.S.SURR
AUDIO SUBTITLE
ADV. SURR STANDARD
PHASE
THX
HDD
CH CH
DVD
DISP
PHOTO
Setting Default
HDMI Audio Amp
Digital Video Conversion On
Speakers A
Surround Back System Normal (default)
Speaker System Front SMALL
Center SMALL
Surr. SMALL
SB SMALLx2
SW YES
Crossover 80 Hz
X-Curve OFF
THX Audio Setting 0–0.3m
Inputs
See Input function default and possible settings on page 65.
MULTI-ZONE
Zone 2 Volume Type Variable
Zone 2 Volume –60
SR+
SR+ Control On/Off OFF
SR+ Volume Control On/Off OFF
Monitor Out OFF
DSP
MCACC Position Memory M1: MEMORY 1
Surround back channel
Processing ON
Phase Control ON
Full Band Phase Control OFF
Sound Retriever OFF
Sound Delay 0 frame
Dual Mono CH1
DRC AUTO
SACD Gain 0 dB
LFE Attenuate 0 dB
Auto delay OFF
Digital Safety OFF
VSX_LX60LX70.book 72 ページ ２００７年７月１８日 水曜日 午前１０時１９分