Panasonic DMC-FZ2A - Manual (Page 100)

Others
100
Troubleshooting
1: The power does not turn on.
1-1: Are the battery and the AC
adaptor correctly connected?
Check the connection.
1-2: Is the battery sufficiently charged?
Use a battery that has been
sufficiently charged.
2: As the power is turned on, it
turns off immediately.
2: Is the battery charge insufficient to
operate the camera? Charge the
battery or replace it with charged
one.
3: The lens and the Viewfinder are
fogged.
3: Has condensation occurred?
Carrying the digital camera from a
cold place to a warm place could
cause condensation on the
camera. Wait until condensation
disappears.
4: The image cannot be recorded.
4-1: Is the Memory Card inside?
4-2: Is the mode dial correctly set ?
Check it.
4-3: There is no memory capacity left
on the card. Before recording,
delete some images.
5: The image is not displayed on
the LCD monitor.
5: Is the the image displayed on the
Viewfinder? Press the [DISPLAY]
button to switch to LCD monitor
display.
6: The LCD monitor/Viewfinder is
too bright or dark.
6: Adjust the brightness of the LCD
monitor/Viewfinder.
7: Flash does not fire.
7: Is the flash closed? Press the
[
OPEN] button to open the
flash.
8: The display or images on the
LCD monitor/Viewfinder are not
focused.
8: Set the mode dial to the mode
corresponding to the distance to
the subject.
9: The image cannot playback.
9-1: Is the Card inside?
9-2: There is no image in the Card.
9-3: The mode dial is not set to
playback [ ].
FZ2-A.book 100 ページ ２００３年８月６日 水曜日 午前１０時０分