Panasonic DMC-FZ2A - Manual (Page 19)

Preparation
19
Attaching the Lens Hood
When attaching the lens hood during the
shining daytime, the sunshine is interrupted
directly and you can take the beautiful picture.
You can prevent the ghost and the flare by
using the lens hood.
[Preparation]
• Check that the power switch is set to [OFF]
and the lens barrel is stored.
• Close the flash. (P37)
1 Remove the lens ring.
2 Attach the lens hood adaptor 1
(supplied).
• The mark ±, ¥ will be the opposite
side of the camera.
3 Attach the lens hood 2 (supplied).
• Adjust the mark of the lens hood to the
mark ± of the lens hood adaptor.
Then, rotate the lens hood to the
mark
¥ and fix it.
• Be careful not to rotate the lens hood
adaptor.
4 Rotate the lens hood and the lens
hood adaptor until the mark of the
lens hood is fitted to the mark of the
camera.
• If the marks are not fitted, edges of the
screen may become dark. (vignetting
effect)
• When taking pictures with flash, flash light is
interrupted by the lens hood and the bottom
of the screen becomes dark. (vignetting
effect)
We recommend to remove the lens hood/
lens hood adaptor.
• Even when the lens hood is attached, you
can attach the lens cap without the string.
3
4
1
2
FZ2-A.book 19 ページ ２００３年８月６日 水曜日 午前１０時０分