Pioneer VSX-LX50 - Manual (Page 65)

Controlling the rest of your system 12
65
En
6 If necessary, press the input source button for the
component whose command you want to input.
This is only necessary if the command is for a new
component (input source).
7 Select the button for the command you want to
input.
The following remote control commands can be
selected:
• You don’t need to program the receiver to switch on
or off. This is done automatically.
With Pioneer components , you don’t need to:
• program the power to switch off in a shutdown
sequence (except DVD recorders);
• program the power to switch on if it’s the source
component selected in step 3;
• program a Pioneer TV or monitor to switch on if the
input function (selected in step 2) has video input
terminals;
These take priority in multi operations (not shutdown).
8 Repeat steps 5–7 to program a sequence of up to
five commands.
9 When you’re finished, use / to select EDITEXIT
from the menu and press ENTER .
You will return to the remote control SETUP menu. Select
* EXIT * again to exit.
Using multi operations
You can start multi operations with the receiver switched
on, or in standby.
1 Press MULTI OPE.
MULTI OP flashes in the display.
2 Press an input source button that has been set up
with a multi operation.
The receiver switches on (if it was in standby) and the
programmed multi operation is performed automatically.
Using System off
1 Press MULTI OPE.
MULTI OP flashes in the display.
2 Press SOURCE .
The command sequence you programmed will run, then
all Pioneer components will switch off
1
, followed by this
receiver.
ANALOG
ATT
MIDNIGHT/
LOUDNESS
DIMMER
SLEEP
SR+
+10 D.ACCESS
DIALOG E
S.RETRIEVER
CLASS DISC
RECEIVER SOURCE
SYSTEM OFF
INPUT
SELECT
ENTER
TUNE
TUNE
ST ST
ENTER
TOP MENU
AV PARAMETER CH LEVEL
PTY SEARCH
T.EDIT
MENU
RETURN
GUIDE BAND
SETUP
TV DVR 1 TV CTRL
iPod RECEIVER TUNER HDMI 1
DVD
CD HDMI 2 CD-R/TAPE
DVR 2 USB
RECEIVER
TV CONTROL
SHIFT
VOL
STATUS SIGNAL SEL
THX ADV.SURR
SB ch
INPUT
SELECT TV CH
MPX
A
B C D E
EON
AUDIO
DISP
SUBTITLE
MULTI OPE STANDARD
PHASE S.DIRECT MCACC
REC
MUTE
TV VOL
REC STOP JUKEBOX
HDD
CH CH
DVD
STEREO/
F.S.SURR
PHOTO
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.
SHIFT
STATUS SIGNAL SEL
THX ADV.SURR
SB ch
AUDIO
DISP
SUBTITLE
MULTI OPE STANDARD
PHASE S.DIRECT MCACC
HDD
CH CH
DVD
RECEIVER
STEREO/
F.S.SURR
PHOTO
RECEIVER SOURCE
SYSTEM OFF
INPUT
SELECT
TV DVR 1 TV CTRL DVD
DVR 2 USB
SHIFT
STATUS SIGNAL SEL
THX ADV.SURR
SB ch
AUDIO
DISP
SUBTITLE
MULTI OPE STANDARD
PHASE S.DIRECT MCACC
HDD
CH CH
DVD
RECEIVER
STEREO/
F.S.SURR
PHOTO
VSX-LX50.book 65 ページ ２００７年４月１２日 木曜日 午後５時３分