Panasonic 8045 - Manual (Page 172)

172
Setting Your Machine
Fax Parameter Table
No. Parameter Setting Comments
153 TSI Routing Invalid Selecting whether to route a received fax to a telephone number, or an email
Valid address preprogrammed in the Address Book using the originating fax’s
Numeric ID (TSI frame information).
154 Route Header FMT Origi Selecting the type of email header to be included in the “From” field of each
(Originator) routed fax.
Rly Stn Originator : The originating fax machine’s TSI will appear in the “From”
(Relay field of the routed email.
Station) Relay Station : The routing station’s email address will appear in the “From”
field of the routed email.
155 Print Routed Doc Inc Only Selecting whether a received fax to be routed is always printed, or only when
Always the routing operation fails.
156 Print Forward Doc Inc Only Selecting whether a memory received fax or email to be forwarded is always
Always printed, or only when forwarding is incomplete.
157 Transaction JRNL Invalid Selecting whether the machine sends a transaction journal to the
Valid pre-programmed email address.
158 PC Remote Update Invalid Selecting whether the machine will accept commands from an email
Valid application, to:
(a) Program the Internet Parameters
(b) Program the Address Book
(c) Allow retrieval of the Journal
160 Default Domain Invalid Selecting whether the machine accepts to insert the Default Domain when
Valid entering Manual Number Dialling.
162 TIFF Viewer URL None Selecting whether to include the URL address in the email message body.
English
Eng+Jpn
163 Routing Header Off Selecting whether to add the Header Print information of the Routing Station
On on the top edge of each routed page.
164 Ifax XMT Header Included Selecting whether to include the header when sending a document to an
(Email only) Not Inc. addressee in the same Domain as specified in the Default Domain parameter.
(This is useful when using the machine to scan documents back to your PC)
Note: When sending to a Domain other than as specified in the Default
Domain parameter, the header will be included regardless of the
selection.