Pioneer DV-989AVi-G - Manual (Page 15)

Connecting up 02
15
En
Connecting using the component
video output
You can use the component video output
instead of the standard video out jack to
connect this player to your TV (or other equip-
ment).
• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT jacks to a component video
input on your TV, monitor or AV receiver.
Connecting using the D1/D2 video
output
Except Australian model
If your TV is equipped with a D-type video
input, you can use a D video cord to connect
this player to your TV.
• Only NTSC video is output when set to
progressive scan.
• This player is compatible with D1, D2, D3
and D4 inputs. However, when connected
to a D1 connector, only interlace video is
output.
• If you connect one or both of the S-video
jacks and the D video connector, and one
of the connected components is not S1/
S2 compatible, the automatic aspect ratio
switching will not work with any of the
connected components.
Connecting for multichannel
surround sound
To enjoy multichannel surround sound from
DVD-Video, DVD-Audio and SACD discs, we
recommend connecting this player to an AV
receiver using the 5.1 channel analog outputs
or the i.LINK connector.
The player also has optical and coaxial digital
outputs should you want to use an external
decoder or the decoder in your AV receiver.
Note that multichannel DVD-Audio and SACD
audio is not output through these jacks, so
this connection should be in addition to,
rather than instead of, a 5.1 channel analog
connection.
You’ll probably also want to connect a video
output to your AV receiver. You can use any of
the video outputs available on this player (the
following illustrations show a standard
(composite) connection).
CONTROL
IN
S-VIDEO OUT VIDEO OUT COMPONENT VIDEO OUT
P B P R Y 2 1 2 1 OUT
AC IN
D1/D2 VIDEO OUT
TV
COMPONENT
VIDEO IN
CONTROL
IN
S-VIDEO OUT VIDEO OUT COMPONENT VIDEO OUT
P B P R Y 2 1 2 1 OUT
AC IN
D1/D2 VIDEO OUT
TV
D1 VIDEO
INPUT
DV-989AVi _YP.book Page 15 Thursday, August 11, 2005 3:28 PM