Pioneer DV-989AVi-G - Manual (Page 28)

Getting Started 04
28
En
Chapter 4
Getting Started
Setting the TV System
The default setting of this player is AUTO , and
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to
AUTO . If you experience picture distor-
tion with some discs, set the TV system to
match your country or region’s system. Doing
this, however, may restrict the kinds of disc
you can watch. The table below shows what
kinds of disc are compatible with each setting
(
AUTO , PAL and NTSC ).
1 If the player is not plugged in, plug it
in now, but leave it in standby.
2 Using the front panel controls, hold
down then press POWER to
switch the TV system.
The TV system changes as follows:
AUTO NTSC
NTSC PAL
PAL AUTO
The player’s display indicates the new setting.
• You have to switch the player into standby
(press on the remote) before each
change.
• If you’re watching an NTSC disc on a PAL
TV, you will only be able to see interlace
video. Progressive scan video is not
compatible with the
MOD.PAL setting.
Watching NTSC on a PAL TV
Most models of the newly developed count-
down PAL TV system detect 50 Hz (PAL)/60 Hz
(NTSC) and automatically switch vertical
amplitude, resulting in a display without
vertical shrinkage.
If your PAL TV does not have a V-Hold control,
you may not be able to watch NTSC discs
because of picture roll. If the TV has a V-Hold
control, adjust it until the picture stops
rolling.
On some TVs, the picture may shrink verti-
cally, leaving black bands at the top and
bottom of the screen. This is not a malfunc-
tion; it is caused by the NTSC to PAL conver-
sion.
Switching on
After making sure that everything is
connected properly and that the player is
plugged in, press
POWER to switch the player
on.
Also, switch on your TV and make sure that it
is set to the input you connected the DVD
player to.
Disc Player setting
Type
DVD
Video CD
CD / no disc
Format
NTSC
PAL
NTSC
PAL
–
NTSC
NTSC
PAL
NTSC
NTSC
NTSC
PAL
MOD.PAL
PAL
MOD.PAL
PAL
PAL
AUTO
NTSC
PAL
NTSC
PAL
NTSC or PAL
DV-989AVi _YP.book Page 28 Thursday, August 11, 2005 3:28 PM