Polycom DOC2585A - Manual (Page 31)

2-1
2
First Time Installation and
Configuration
First Time Installation and Configuration of the Polycom RMX 1500/2000/4000
consists of the following procedures:
1
Preparations:
—
Gather Network Equipment and Address Information - get the
information needed for integrating the RMX into the local
network.
— Unpack the RMX.
— Modify the Management Network parameters on the USB Key.
2 Hardware Installation and Setup
—
Mount the RMX in a rack.
— Connect the necessary cables.
3 First Entry Power-up and Configuration
—
Power up the RMX.
— Register the RMX.
— Connect to the RMX
— Configure the Default IP Network Service.
— Configure the ISDN/PSTN Network Service.
Preparations
Hardware
Installation
and
Setup
First Entry
Power-up and
Configuration