Procedure 4: modifying the default ip service and, Isdn/pstn network service settings -22 – Polycom DOC2585A User Manual
Page 52
Chapter 2-First Time Installation and Configuration
2-22
Procedure 4: Modifying the Default IP Service and ISDN/
PSTN Network Service Settings
The Fast Configuration Wizard assists in configuring the Signaling Network
Service. It starts automatically if no Signaling Network Service is defined.
This happens during First Time Power-up, before the service has been
defined or if the Signaling Service has been deleted, followed by an RMX
restart.
The IP Management Service tab in the Fast Configuration Wizard is enabled
only if the factory default Management IP addresses were not modified.
On the RMX 1500, RMX 2000 and RMX 4000, IPv4 is the default protocol for
setting the Network Service in the Fast Configuration Wizard.
If IPv6 addressing is required, complete the Fast Configuration Wizard and
then:
1
Modify the Management Network to use IPv6 addressing or IPv4 and IPv6
addressing.
2
Restart the RMX.
3
Use the Fast Configuration Wizard which will now include IPv6 addressing
or IPv4 & IPv6 addressing options to configure the Signaling Network
Service.
For detailed description of the IP Network Services, see the RMX 1500/2000/
4000 Administrator’s Guide.