Pioneer DVR-510H - Manual (Page 27)

Getting started 04
27
En
• SMART JOG on the front panel
Note
• Antenna channels are numbered 2 through 69. Cable
channels are numbered 1 through 125.
• You can’t change TV channels during playback (from
DVD or HDD) or recording, or while in recording
standby.
Changing audio channels
Some TV programs are broadcast with both a main and a
Second Audio Program (SAP). You can change the TV
audio using the
AUDIO button.
• Press AUDIO to change the TV audio.
The current audio channel is displayed on-screen.
• If SAP is selected, but there is no SAP channel being
broadcast, you will still hear the main audio channel.
• If the sound is poor quality when set to Stereo , you
can often improve it by changing to Mono .
Basic playback
This section shows you how to use your recorder for
playback of discs (DVD, CD, etc.), and for playback of
video from the HDD. More playback features, such as
repeat and program play, are covered in the next chapter.
Important
• Throughout this manual, the term ‘DVD’ means
playback-only DVD-Video discs and DVD-R/RW. If a
function is specific to a particular kind of DVD disc, it
is specified.
• Some DVD-Video discs don’t allow certain playback
controls to operate at certain points in the disc. This
is not a malfunction.
1 Press STANDBY/ON to switch on.
Also turn on your TV and make sure that it is set to the
correct video input.
2 Select HDD or DVD for playback.
Use the HDD and DVD buttons on the remote, or the
HDD/DVD button on the front panel.
If playing video from the HDD, skip to step 5 below.
3 Press OPEN/CLOSE to open the disc tray.
4 Load a disc.
Load a disc with the label side facing up, using the disc
tray guide to align the disc (if you’re loading a double-
sided DVD-Video disc, load it with the side you want to
play face down).
• If you want to play a DTS audio CD, please first read
the note on page 29.
5 Press PLAY to start playback.
• If you’re playing a DVD-Video or Video CD, a disc
menu may appear when you start playback. Use the
/ / / (cursor) buttons and ENTER to navigate
DVD disc menus, and the number buttons and
ENTER for Video CD menus.
• See the following sections for more details on playing
specific kinds of discs.
6 To stop playback, press STOP.
7 When you’ve finished using the recorder, eject
the disc and switch the recorder back into standby.
• To open/close the disc tray, press OPEN/CLOSE .
Remove the disc before putting the recorder into
standby.
AUDIO
Mono SAP
Stereo
STANDBY/ON OPEN/CLOSE
ENTER
STOP
PLAY
DVR-03_HDD_KU.book 27 ページ ２００３年８月７日 木曜日 午前１０時４０分