Pioneer DVR-510H - Manual (Page 96)

The Initial Setup menu 13
96
En
• Select by code number: Press (cursor down) then
use the number buttons to enter the 4-digit language
code.
See Language code list on page 108 for a list of available
languages and corresponding codes.
3 Press ENTER to confirm and exit the screen.
Recording settings
Manual Recording
• Default setting: Off
On the default setting there are four different recording
time/picture quality settings,
FINE , SP , LP and EP . If you
want to create a custom setting, switch on Manual
Recording and select one of the 32 manual settings.
When recording, you can select your Manual Recording
setting using the
REC MODE button.
1 Select ‘On (go to setup)’ to display the manual
recording setting screen.
2 Use the / (cursor left/right) buttons to
change the manual recording level.
• You can also use the and buttons to cycle
between levels MN1 , MN9 , MN21 and MN32 .
• To preview the recording quality, press (cursor
down) and select Preview . To return to the level
adjust screen, press ENTER .
3 Press ENTER to set the manual recording level
and return to the menu screen.
Note
• The preset picture quality settings correspond to the
following manual settings: FINE : MN32 , SP : MN21 ,
LP : MN9 , EP : MN1 .
• See page Manual recording modes on page 107 for
detailed information on the manual recording levels.
Optimized Rec
• Default setting: Off
On the default setting, if a timer program (standard, easy
or VCR Plus+ programming system) is set but there isn’t
enough space on the disc at the recording quality set, the
recording will start, but it will be cut off when the disc is
full. Set
Optimized Rec to On to have the recorder
automatically adjust the recording quality to fit the
available disc space.
Note
• You may notice a reduction in picture quality if the
recorder has to fit a lot of extra material into the
remaining time available on the disc.
• If, even on recording level MN 1 , there is insufficient
space available on the disc, the recording is made at
level
MN 1 but recording will stop once the disc is
full.
• Optimized Recording only compensates for the first
(earliest starting) timer program if more than one has
been set.
• Optimized recording works only with DVD
recordings.
Navi Mark
• Default setting: 0 seconds
In the Disc Navigator, each title is shown with a still
frame picture to remind you what it is. This setting lets
you decide the default still frame. The default setting of
0
seconds takes the first frame of the title, but you can also
set it to 30 seconds or 3 minutes into the title (if the title
is shorter than the setting, then the first frame is used).
Basic
Tuner
Video Out
Audio In
Audio Out
Language
Recording
Playback Manual Recording
Optimized Rec
Navi Mark
Auto Chapter (Video)
Frame Accurate
DVD-RW Auto Init. On (go to setup)
Off
Initial Setup
32ch
EP LP SP FINE
Preview
DVD Remain 2h00m HDD Remain 2h33m
MN 9 (4h00m/DVD) 2.60Mbps
Basic
Tuner
Video Out
Audio In
Audio Out
Language
Recording
Playback On
Off Manual Recording
Optimized Rec
Navi Mark
Auto Chapter (Video)
Frame Accurate
DVD-RW Auto Init.
Initial Setup
Basic
Tuner
Video Out
Audio In
Audio Out
Language
Recording
Playback 0 seconds
30 seconds
3 minutes Manual Recording
Optimized Rec
Navi Mark
Auto Chapter (Video)
Frame Accurate
DVD-RW Auto Init.
Initial Setup
DVR-03_HDD_KU.book 96 ページ ２００３年８月７日 木曜日 午前１０時４０分