Audio out settings, The initial setup menu 13 – Pioneer DVR-510H User Manual

Page 93

Advertising

The Initial Setup menu

DV Input

• Default setting:

Stereo1

You need to set this if you have a camcorder using 32kHz/
12-bit sound connected to the front panel

DV IN/OUT

jack.

Some digital camcorders have two stereo tracks for
audio. One is recorded at the time of shooting; the other
is for overdubbing after shooting.

On the

Stereo1

setting, the sound that was recorded

while shooting is used. On the

Stereo2

setting, the

overdubbed sound is used. You can also choose a

Mix

setting of 25%, 50% or 75% for the Stereo 1 with a
corresponding Stereo 2 setting of 75%, 50% or 25%.

Input Level (L1 / L2 / L3)

• Default setting:

0dB

You can adjust the gain of the audio from each external
input individually, from

–6dB

+6dB

in steps of 3 dB to

optimize the recorded audio level.

Audio Out settings

Digital Out

• Default setting:

If at any time you need to switch off the digital audio
output, set this to

Off

, otherwise leave it

Note

• When set to

Off

, all the other

Audio Out

settings are

grayed out and can’t be set.

Dolby Digital Out

You only need to make this setting if you connected this
recorder to an AV amplifier (or other component) using the
digital output.

• Default setting:

Dolby Digital

If your AV receiver (or other connected component) is
Dolby Digital compatible, set to

Dolby Digital

, otherwise

set to

Dolby Digital

PCM

. Check the manual that

came with the connected component if you’re unsure
whether it is Dolby Digital compatible.

DTS Out

You only need to make this setting if you connected this
recorder to an AV amplifier (or other component) using the
digital output.

• Default setting:

If your AV receiver (or other connected component) has a
built-in DTS decoder, set to

, otherwise set to

Off

Check the manual that came with the connected
component if you’re unsure whether it is DTS
compatible.

Important

• If you set to

with a non-DTS compatible amplifier,

noise will be output when you play a DTS disc.

• When set to

, there is no analog audio output

when playing a DTS DVD-Video disc.

• When playing a DTS audio CD (even when

DTS Out

Off

), noise is output from the analog outputs.

not play this through your amplifier and speakers.