Pioneer DV-S733A - Manual (Page 16)

16
En
Getting Started 4
Setting the TV System
(except for Taiwanese model)
The default setting of this player is AUTO,
and unless you notice that the picture is
distorted when playing some discs, you
should leave it set to AUTO.
If you experience picture distortion with
some discs, set the TV system to match
your country or region’s system. Doing
this, however, may restrict the kinds of
disc you can watch. The table below shows
what kinds of disc are compatible with
each setting (AUTO, PAL and NTSC).
About MOD. (Modulation) PAL
• SHRINK
Most models of the newly developed countdown
PAL TV system detect 50 Hz (PAL)/60 Hz
(NTSC) and automatically switch vertical
amplitude, resulting in a display without vertical
shrinkage.
• If your PAL TV does not have a V-Hold control,
you may not be able to view NTSC disc because
the picture may roll. If the TV has a V-Hold
control, adjust it until the picture stops rolling.
On some TVs, the picture may shrink vertically,
leaving black bands at the top and bottom of the
screen. This is not a malfunction; it is caused by
the NTSC
]PAL conversion.
Note
This front panel is for the DV-S733A. The
buttons are the same for the DV-47A.
1 Switch the player into standby.
2 Hold down
¡ ¢ then press STANDBY/
ON to switch the TV system.
The TV system changes as follows:
AUTO
] NTSC
NTSC
] PAL
PAL
] AUTO
The display indicates the new setting.
Note that you have to switch the player into
standby before each change.
¡ ¢ STANDBY/ON
0 8 7 ¡ ¢ 4 1 3 STANDBY/ON FL OFF LEGATO PRO DIGITAL DATA OFF Î
Disc Output format
Position of TV SYSTEM switch Type Format
NTSC PAL AUTO
DVD NTSC NTSC MOD. PAL NTSC
PAL PAL PAL
Video CD NTSC NTSC MOD. PAL NTSC
PAL PAL PAL NTSC
Super VCD NTSC NTSC MOD. PAL NTSC
PAL PAL PAL
SACD NTSC PAL NTSC or PAL
CD, No disc NTSC PAL NTSC or PAL