Pioneer DV-S733A - Manual (Page 46)

46
En
DVD Setup Menu 7
Gain Settings
• Default setting: Fix
You may want to make this setting if you connected this
player to your amplifier using the 5.1 channel analog
outputs.
Under the default setting, all channels are output at
the relative volumes they were recorded at. Change
the setting to Variable if you want to adjust the
relative volume levels of any of the speakers.
Adjustment is in the range of -6dB to +6dB, in steps
of 0.5dB.
• When set to Variable, the overall output level
may sound quieter than when set to Fix. This is
not a malfunction.
Note
Gain settings are not effective when playing a CD
with CD Digital Direct set to On.
—
—
—
—
—
Audio2 Video1 Language General A1 V2
Exit Move SETUP Select ENTER
Virtual Surround
Legato PRO
Audio Out
Speaker Setting
Gain Setting
Hi–Bit
CD Digital Direct
Off
Off
2 Channel
Fix
Variable
Off
Exit Select Test Tone
Return
Audio2 Video1 Language General A1 V2
L
C
R
RS
LS
SW
Gain Setting
— 0.0 dB
— 0.0 dB
— 0.0 dB
— 0.0 dB
— 0.0 dB
— 0.0 dB
L R
SW
LS RS
SETUP ENTER
To help you gauge the correct gain levels, set the
Test Tone to On (test tone from just that speaker)
or Auto (test tone from each speaker in turn,
excluding the subwoofer) then adjust the gain so
that all speakers appear to be the same volume from
your listening position.
Follow the on-screen displays to select speakers and
set the channel levels.
• You can adjust the Test Tone setting only when
the player is stopped.
• Many AV amplifiers allow you to make similar
settings at the amplifier stage. In this case, set
the channel levels at the player or the amplifier,
not both.
• As the test tone plays through a speaker, its name
is highlighted in yellow on-screen.
Exit Select Gain
Return
Audio2 Video1 Language General A1 V2
L
C
R
RS
LS
SW
Test Tone
— Off
— Off
— Off
— Off
— Off
— Off
L R
SW
LS RS
SETUP ENTER
Remember
You can't use the test tone function when the Audio
Out setting is 2 Channel (see page 43).The test
tone will not work with the disc tray open, or while a
disc is playing.
CD Digital Direct
• Default setting: Off
Setting this to On increases CD audio quality by
bypassing certain audio circuits in the player
that audio signal would otherwise pass through.
However, this must be set to Off for proper
playback of DTS encoded CDs.
—
—
—
—
—
Audio2 Video1 Language General A1 V2
Exit Move
Virtual Surround
Legato PRO
Audio Out
Speaker Setting
Gain Setting
Hi–Bit
CD Digital Direct
Off
Off
2 Channel
Fix
On
Off
SETUP
Remember
If this setting is set to On when a DTS CD is
playback, noise is produced.
Press ENTER