Profoto ACUTE2 1200 - Manual (Page 17)

17
Energy distribution
The energy can be controlled over a 6 f-stop range or 7 when
using 2 heads connected to the B sockets. The energy output
through the outlets A (17) and B (19,20) is controlled by the
A+B / A<->B switch (13), the
switches A and B (12+14) and the dial BRACKET (15).
The nominal energy of the flash unit is divided equally into
two groups, A and B, and the two groups can either be
combined or separated with the A+B / A<->B switch (13).
The energy in group A is controlled by the A-switch (12) and
the energy in group B is controlled by the B-switch (14).
In each group the energy can be halved or quartered.
Please see panel for details.
Below you will find detailed description on how to control
the energy if you use one, two or three Acute2 heads or if
you use a Acute2 twin.
Always start with settin g the BRACKET dial(15) to max,
the A- and B switch at full and the A+B / A<->B switch
(13) in position A+B. You now have maximum energy.
Full f-stop changes are done with the A- or/and B-switch.
Fine adjustments or further f-stop reductions are done with
the BRACKET dial.
(12) (13) (14)
(15)
(17) ( 19) (20)