Tuner settings, The initial setup menu 14 – Pioneer OPERATING INSTRUCTIONS DVR-920H User Manual

Page 109

Advertising

The Initial Setup menu

109

English

Remote Control Mode

• Default setting:

Recorder1

You only need to set this if you are using more than one
Pioneer DVD recorder in the same room.

So that each remote control operates only its own
recorder, make this setting different for each recorder
and remote in the room.

There are three different recorder IDs. When set to

Recorder2

Recorder3

, the remote control mode is

shown in the front panel display.

After selecting a new recorder ID, you have to confirm the
change by selecting

Yes

(use the

(cursor

left/right) buttons), then pressing

ENTER

Note that as soon as you change the recorder ID, the
remote becomes inoperative until you change the remote
to the same ID.

To set the remote, press and hold

RETURN

and a number

button (

) until the indicator on the remote lights.

AV Link

• Default setting:

This Recorder Only

This setting determines how AV Link signals are handled
when the recorder is in standby. Choose the

This

Recorder Only

setting for AV Link signals to affect only

this recorder. Choose

Pass Through

to have this

recorder pass on AV Link signals to other connected
devices without affecting this recorder.

Setup Navigator

• Default setting:

n/a

The Setup Navigator appears automatically when you
switch on the recorder for the first time (or after resetting
the recorder). It is also available from the Initial Settings
menu should you need it at any other time.

See also

Switching on and setting up

on page 26.

Tuner settings

Auto Channel Setting : Auto Scan

This recorder has a built-in TV tuner for recording PAL B/
G, PAL I, SECAM L and SECAM D/K TV programs off the
air or from analog cable TV. We recommend that you first
use the Auto Channel Setting described here to tune into
the channels in your area, then if there are any unwanted
channels, you can disable them using Channel Skip
(described below). You can also fine-tune individual
stations using the

Manual CH Setting

feature. See

Manual CH Setting

below for how to use this.

Choose ‘Tuner’ from the Initial Setup menu, then

‘Auto Channel Setting’, then ‘Auto Scan’.

Select your country then press ENTER to start

tuning.

• You can cancel before auto tuning has finished by

pressing

ENTER

again.