Pioneer OPERATING INSTRUCTIONS DVR-920H - Manual (Page 19)

Connecting up 02
19
En
English
Connecting to an AV amplifier/receiver
To enjoy multichannel surround sound you need to connect this recorder to an AV amplifier/receiver using the digital
optical output.
In addition to a digital connection, we recommend also connecting using the stereo analog connection for
compatibility with all discs and sources.
You’ll probably also want to connect a video output to your AV amplifier/receiver. Use the ordinary video output (as
shown here), or the S-video output.
Important
• Noise may be output from your speakers if the recorder is not set up to work with your AV amplifier/receiver
properly (see Audio Out settings on page 114).
1 Connect RF antenna cables as shown.
This enables you to watch and record TV channels.
2 Connect one of the DIGITAL OUT OPTICAL jack on
this recorder to an optical digital input on your AV
amplifier/receiver.
This enables you to listen to multichannel surround
sound.
3 Connect the analog AUDIO OUTPUT and VIDEO
OUTPUT jacks on this recorder to an analog audio
and video input on your AV amplifier/receiver.
4 Connect the AV amplifier/receiver’s video output
to a video input on your TV.
Important
• Do not connect this recorder to your TV ‘through’
your VCR using A/V cables. Always connect it directly
to your TV.
TV
AV amp/
receiver
Antenna/cable TV
wall outlet
COMPONENT VIDEO OUT
AC IN
DIGITAL AUDIO OUT
OPTICAL
COAXIAL
CONTROL
G-LINK IN
IN
OUT
ANTENNA
R L AUDIO VIDEO S-VIDEO
Y
P B
P R
OUT PUT HDMI OUT
IN PUT 3
AV 1 (RGB) - TV AV 2 (INPUT 1/DECODER)
ANTENNA
IN
VIDEO
IN
DIGITAL
IN
A/V
IN 1
VIDEO
OUT
1
3
2
1
4
DVR-04_HDD_UK.book 19 ページ ２００４年９月１０日 金曜日 午後７時３分