Printek 850 Series - Manual (Page 66)

S P E C I F Y I N G F O R M S
5 8
selected (0 to 28K bytes in 1K byte increments) should be set to
accommodate the largest page expected, but not unnecessarily large since
the larger this is set, the smaller the effective I/O buffer. The 8K-byte
default setting should be large enough to hold most pages of text, but may
not be large enough to hold more complex or graphic filled pages. If the
page size selected is not large enough, the page will be broken as described
under Paper Out Fault Action item above.
If the Paper Out Fault Action item is set to Break Page, the Reprint
Page Size may be set to
0 to allow the largest possible I/O buffer.
Truncate Long Lines Truncate Lines
No
Possible Values: Yes, No*
When this item is set to Yes, long text lines that would wrap around to the
next line will be terminated at the right margin column or the right usable
edge of the platen, whichever is reached first. The remainder of the
characters in the line are discarded. Graphics printing always truncates.
Bottom Paper Slew Rate
852si only
Bottom Slew
Fast
Possible Values: Normal, Fast*
In the PrintMaster 852si, this item controls the speed of paper in the bottom
paper path. When this item is set to Fast, paper motion will take place at
12 inches per second. When set to Normal, this speed is the same as the
rear paper path. This setting may be necessary when using thick multi-part
forms that tend to de-laminate or have bulky perforation “tents”.