Printek 850 Series - Manual (Page 83)

U S I N G T H E O P T I O N A L S E T U P M O D U L E
7 5
the ONLINE indicator will be yellow. When the message disappears,
installation is complete and the printer will continue with its normal
power up procedure.
Initializing
Setup Module
7. The printer will now compare the configuration data in its internal
memory to the data in the Setup Module. If the data are not an exact
match, the printer will proceed with step 8.
If the data in the printer and the data in the module are an exact
match, installation is complete and the printer will complete its power
up procedure.
8. The printer has now determined that the data in the Setup Module
does not exactly match the data in the printer’s internal memory. The
printer will now display the following message, the ONLINE indicator
will flash yellow and the bell will beep to get the operator’s attention.
Proceed to step 9.
New Setup
Module
Detected
9. Press the ONLINE button. The printer will now stop flashing the
ONLINE indicator (will remain yellow) and display the following
message. You must now make one of the selections as described
below.
LOAD=READ
UNLOAD=WRITE