Precor MOVE BEYOND 9.23 - Manual (Page 40)

Owner’s Manual: Advanced Programming and Troubleshooting 38
5. Press ENTER to accept the displayed setting.
The change will be retained in memory even if the
treadmill is turned Off and unplugged.
6. If you want to exit without saving the change, press
STOP.
Informational Displays
The treadmill provides information about its use (odometer
and hour meter), as well as the software version. In
general, you would only access this information if directed
to do so by Precor Customer Support.
These instructions guide you through the informational
displays. Pressing the ENTER key resets the odometer
and hour meter. To exit without resetting, press STOP at
any time.
Viewing the Odometer
1. Remove the magnetic safety key.
2. Replace the magnetic safety key and within 2 seconds
press the following keys:
STOP, INCLINE ▲ and SPEED ▼
Note: If the keys are not pressed within the 2-second
window, the banner appears and you must begin again.
3. ODOMETER appears in the display.
The software version appears in the center display. The
odometer value (the cumulative miles or kilometers
users have traveled) appears in the DISTANCE display.
The furthest digit on the left marks the hundred-
thousandths position, while the furthest digit to the
right indicates tenths of a mile or kilometer.
The TIME display provides the hour meter (the number
of hours the unit has been in use). If you have not used
the treadmill for more than an hour, a zero will appear in
the TIME display.
4. To exit without making changes, press STOP.
92x_Owners Manual.book Page 38 Tuesday, April 22, 2008 8:18 AM