Precor MOVE BEYOND 9.23 - Manual (Page 41)

Owner’s Manual: Advanced Programming and Troubleshooting 39
Red Reset Button
A red button, near the power switch, resets the treadmill’s
circuit breaker. If the running belt stops unexpectedly and
all display console functions cease, the circuit breaker may
have been tripped.
To reset the system, take the following steps:
1. Use the power switch beneath the front panel to turn
the treadmill Off.
2. Make sure the treadmill is located away from heating
ducts. If necessary, move the treadmill to an
appropriate location. Refer to Location.
3. Wait a few minutes. Make sure the magnetic safety key
is properly positioned on the display console.
4. Push the red reset button, and then turn the treadmill On.
5. Check the display to verify that the Precor banner is
scrolling across the display. If the display remains
blank, call Precor customer support. Refer to Obtaining
Service.
Troubleshooting Error Codes
Initially, when the unit is turned On, the display lights all the
LEDs. If any are dark, call an authorized service person for
assistance.
The following table shows the error codes that may
appear in the display. If you see these error codes, call an
authorized service person for assistance because the
treadmill needs to be recalibrated. Refer to Obtaining
Service.
Code Description
E3 EEPROM error.
E26 Speed signal is not being received.
E40 A problem occurred with the lift.
92x_Owners Manual.book Page 39 Tuesday, April 22, 2008 8:18 AM