NEC LT380 - Manual (Page 17)

7
1. Introduction
Terminal Panel Features
PC CARD
COMPONENT IN
USB LAN
AUDIO IN
COMPUTER 3 IN
COMPUTER 1 IN COMPUTER 2 IN
PC CONTROL MONITOR OUT AUDIO OUT
S-VIDEO IN VIDEO IN AUDIO IN
Cb/Pb
L/MONO R
Y Cr/Pr
14 3
2
11 5 6 9 10 8
7
1 4 13 12 15
1. COMPUTER 1 IN/Component Connector (Mini D-
Sub 15 Pin) (
→ page
13 , 15 , 16 )
2. COMPUTER 2 IN/Component Connector (Mini D-
Sub 15 Pin) (
→ page
13 , 16 )
3. COMPUTER 3 IN Connector (DVI-D 24 Pin) (HDCP
compatible) (
→ page
14 ) (Not available on LT280)
4. AUDIO IN (Stereo Mini Jack) (
→ page
13 , 14 , 16 )
5. MONITOR OUT Connector (Mini D-Sub 15 Pin) (
→
page 16 )
6. AUDIO OUT (Stereo Mini Jack) (
→ page
16 )
7. COMPONENT IN (Y, Cb/Pb, Cr/Pr) Connectors
(RCA) (
→ page
17 )
8. S-VIDEO IN Connector (Mini DIN 4 Pin) (
→ page
18 )
9. VIDEO IN Connector (RCA) (
→ page
18 )
10. AUDIO L/MONO, R (RCA) (
→ page
17 , 18 )
11. PC CONTROL Port (Mini D-Sub 9 Pin) (
→ page
116 ,
117 )
Use this port to connect your PC or control system to
control your projector via a serial cable. This enables
you to control the projector using serial communica-
tion protocol. A commercially available RS232C cross
cable is required to use this port. You can also control
the projector by using PC Control Utility 3.0 contained
on the supplied User Supportware 3 CD-ROM. To do
so you must first have PC Control Utility 3.0 installed
on your PC. If you are writing your own program, typi-
cal PC control codes are on page
116 .
12. LAN Port (RJ-45) (
→ page
19 , 48 )
13. USB Port (Type A) (
→ page
35 , 47 )
14. PC CARD Eject Button (
→ page
22 )
15. PC CARD Slot ( → page 21 )
(LT380 only)
The actual appearance of the terminal panel may differ slightly from that shown in the drawing, but this does not affect
the projector's performance.