NEC LT380 - Manual (Page 34)

24
OFF
VIDEO
S-VIDEO
VIEWER
LAN
COMPUTER
COMPONENT
ON
SELECT
POWER POWER
MENU
EN
TER EX IT
3
1 2
POWER ON/STAND BY
PC CARD
LAMP
STATUS
SOURCE AUTO ADJUST 3D REFORM
3. Projecting an Image (Basic Operation)
This section describes how to turn on the projector and to project a picture onto the screen.
ᕡ Turning on the Projector
NOTE:
• The projector has two power switches: a main power switch and a POWER (ON/STAND BY) button (POWER ON and OFF on the
remote control).
• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off ( ⅜ )
position. Failure to do so may cause damage to the projector.
• The projector has a feature to prevent itself from being used by unauthorized individuals. To use this feature, register a keyword.
( → page 42 )
1. To turn on the main power to the projector, press the
Main Power switch to the on position ( I ).
• The POWER indicator will light orange.
See the Power Indicator section on page
107 for more
details.
2. Remove the lens cap.
3. Press the POWER (ON/STAND BY) button on the pro-
jector cabinet or POWER ON button on the remote
control for a minimum of 2 seconds when the power
indicator turns a steady green, and the projector is
ready to use.
• After you turn on your projector, ensure that the computer
or video source is turned on and that your lens cap is
removed.
NOTE: When no signal is available, a blue, black or logo screen is displayed.
PC CARD COMP ONE NT IN
USB
LAN
AUDIO IN COM PU TER 3 IN CO MPUT ER 1 IN
CO MPU TE R 2 IN
PC CONTROL
MO NITO R O UT
AUD IO OUT
S-VID EO IN VID EO IN
AUDIO
Cb/P b
L/M ONO R
Y
Cr/P r
AC I N
PC C ARD LAM P STA TUS POW ER
ON/S TAN D B Y
SO URC E
AUTO AD JUST
3D R EFO RM
SELE CT
PC CARD
LAMP
STATUS
POWER
POWER POWER POWER
STATUS
LAMP
STATUS
LAMP
STATUS
LAMP
ON/STAND BY
Standby
Blinking for
one minute
Power On
Steady orange
light
Blinking green
light
Steady green
light
(
→ page
107 )
Press this button for a
minimum of 2 seconds.