NEC LT380 - Manual (Page 33)

23
2. Installation and Connections
Connecting the Supplied Power Cable
Connect the supplied power cable to the projector.
First connect the supplied power cable's two-pin plug to the AC IN of the projector, and then connect the other plug of
the supplied power cable in the wall outlet.
Make sure that the prongs are fully
inserted into both the AC IN and the
wall outlet.
To wall outlet
PC CARD
COM PON ENT IN
USB
LAN
AUD IO IN COM PUT ER 3 IN COM PUT ER 1 IN
COM PUT ER 2 IN
PC CONTROL
MO NIT OR O UT
AUD IO O UT
Cb/P b
L/M ON O
R
Y
Cr/P r
S-V IDEO IN
VID EO IN
AUD IO IN
AC IN
PC C ARD LAM P STA TUS POW ER
ON/S TAN D B Y
SOU RCE
AUT O A DJU ST
3D R EFO RM
SELECT
CAUTION:
Do not unplug the power cable from the wall outlet under any one of the following circumstances.
Doing so can cause damage to the projector or PC card:
• While the projector's lamp is lighted.
• While the cooling fans are running. The cooling fans continue to work for 30 seconds after the projector is
turned off.
• While the PC CARD Access Indicator lights. Doing so can damage your PC memory card.