NETGEAR MR814 v3 User Manual
Page 28
Reference Manual for the MR814 v3 Cable/DSL Wireless Router
3-4
Connecting the Router to the Internet
202-10039-01
Figure 3-4: Verify the connections according to the status lights on the router
d.
Check the router status lights to verify the following:
•
Power: The power light should turn solid green. If it does not, see
.
•
Test: The test light blinks when the router is first turned on then goes off. If after 2
minutes it is still on, see
“Troubleshooting Tips” on page 3-8
.
•
Internet: The Internet port light should be lit. If not, make sure the Ethernet cable is
securely attached to the router Internet port and the modem, and the modem is
powered on.
•
Wireless: The Wireless light should be lit. If the Wireless light is not lit, see
“Troubleshooting Tips” on page 3-8
•
LAN: A LAN light should be lit. Green indicates your computer is communicating at
100 Mbps; yellow indicates 10 Mbps. If LAN light is not lit, check that the Ethernet
cable from the computer to the router is securely attached at both ends, and that the
computer is turned on.
3. U
SE
THE
S
MART
W
IZARD
TO
CONFIGURE
THE
ROUTER
a.
From the Ethernet connected PC you just set up, open a browser such as Internet Explorer
or Netscape® Navigator.
0OWER
)NTERNET
7IRELESS
,!.
4EST