NETGEAR MR814 v3 - Manual (Page 30)

Reference Manual for the MR814 v3 Cable/DSL Wireless Router
3-6 Connecting the Router to the Internet
202-10039-01
c. Follow the instructions on the screen to enable the wireless feature.
Figure 3-6: Enable the wireless feature
d. Enable your wireless network, click Next to proceed, then click Done to finish. If you
have trouble connecting to the Internet, see
“Troubleshooting Tips” on page 3-8 to correct
basic problems.
Note: The Smart Wizard configuration assistant only appears when the router is in its
factory default state. After you configure the router, it will not appear again. You can
always connect to the router to change its settings. To do so, open a browser such as
Internet Explorer and go to http://www.routerlogin.net. Then, when prompted, enter
admin as the user name and password for the password both in lower case letters.
You are now connected to the Internet and the wireless feature of the router is enabled!
Next, configure your wireless computer.