NETGEAR MR814 v3 - Manual (Page 53)

Reference Manual for the MR814 v3 Cable/DSL Wireless Router
Wireless Configuration 4-13
202-10039-01
Figure 4-7: Wireless Card Access List Setup
4. Click the Turn Access Control On check box.
5. Click Add to add a wireless device to the wireless access control list. The Wireless Card
Access Setup menu displays.
6. Then, either select from the list of available wireless cards the MR814 v3 has found in your
area, or enter the MAC address and device name for a device you plan to use. You can usually
find the MAC address printed on the wireless adapter.
Note: You can copy and paste the MAC addresses from the firewall’s Attached Devices menu
into the MAC Address box of this menu. To do this, configure each wireless computer to
obtain a wireless link to the firewall. The computer should then appear in the Attached
Devices menu.
7. Click Add to add this wireless device to the Wireless Card Access List. The screen changes
back to the list screen. Repeat these steps for each additional device you wish to add to the list.
8. Be sure to click Apply to save your wireless access control list settings.
Now, only devices on this list will be allowed to wirelessly connect to the MR814 v3.